Service Provider Routing and Switching, Specialist (JNCIS-SP) (JN0-362) Free Practice Test

Question 1

You want to make use of the nonstop active routing (NSR) feature.
Which complementary feature must also be enabled?

A. Virtual Router Redundancy Protocol

B. graceful restart

C. IP anycast

D. graceful Routing Engine switchover

Correct Answer: D

Question 2

Click the Exhibit button.

You have configured IPv6 over IPv4 tunneling, as shown in the exhibit. However, hosts connected to network 2001:0:0:1::0/64 cannot communicate with hosts on network 2001:0:0:2::0/64. The router R2 has a similar configuration as the R1 router.
How would you solve this problem?

A. Configure the next hop of the inet6.0 static route to point to the physical interface between the routers

B. Configure an IPv6 address on the tunnel interfaces

C. Configure an IGP across the tunnel interfaces

D. Configure the next hop of the inet6.0 static route to point to the IPv4 address of the remote router

Correct Answer: D

Question 3

Click the Exhibit button.

Referring to the exhibit, which statement is correct?

A. Interface ge-3/0/0.0 has a default metric of 10

B. Interface xe-0/0/0.0 has a default metric of 10

C. Interface xe-0/0/0.0 can only form a single adjacency

D. Interface ge-1/0/0.0 can only form a single adjacency

Correct Answer: A

Question 4

According to Juniper Networks, what are two reasons to peer using loopback addresses when configuring BGP? (Choose two.)

A. When establishing an IBGP connection

B. When routers are not in the same autonomous system

C. When establishing a single-link EBGP connection

D. When routers are not directly connected

Correct Answer: A,D

Question 5

Click the Exhibit button.

Referring to the exhibit, the GRE tunnel between R-1 and R-2 allows connectivity between User-1 and Server-1. When User-1 communicates with Server-2 with packets that are 1472 bytes in size, no packet fragmentation occurs. User-1 can communicate with Server-1 with packets that are up to 1448 bytes in size with no packet fragmentation. However, if the packet size is larger than 1448 bytes, packet fragmentation occurs.
Why is the packet fragmentation occurring between User-1 and Server-1 in this scenario?

A. The GRE header adds 24 bytes to the packet

B. The GRE header adds 20 bytes to the packet

C. The IP header adds 24 bytes to the packet

D. The IP header adds 20 bytes to the packet

Correct Answer: A

Question 6

Click the Exhibit button.

Referring to the exhibit, why is the route hidden?

A. The route has yet to be verified

B. The MPLS LSP to the 192.168.0.2 peer is down

C. The wrong BGP address family is enabled for the BGP session

D. The protocol next hop is not reachable

Correct Answer: D

Question 7

Which two statements are correct about the BGP MED attribute? (Choose two.)

A. BGP uses the MED value when peering to two or more connections to the same upstream AS

B. BGP routes require the MED attribute be defined

C. BGP uses the MED value when peering to two different upstream ASs

D. BGP assumes the MED value to be 0, if not already defined

Correct Answer: A,D

Welcome to TestSimulate

Juniper Service Provider Routing and Switching, Specialist (JNCIS-SP) (JN0-362) Free Practice Test