Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) (350-401) Free Practice Test

Question 1

What is a characteristic of Layer 3 roaming?

A. Clients must obtain a new IP address when they roam between APs.

B. It is only supported on controllers that run SSO.

C. It provides seamless roaming between APs that are connected to different Layer 3 networks and different mobility groups.

D. It provides seamless client roaming between APs in different Layer 3 networks but within the same mobility group.

Correct Answer: D

Question 2

Which function is performed by vSmart in the Cisco Catalyst SD-WAN architecture?

A. facilitation of NAT detection and traversal

B. distribution of IPsec keys

C. redistribution between OMP and other routing protocols

D. execution of localized policies

Correct Answer: C

Question 3

Correct Answer:

See the solution below in Explanation:
Explanation:
Solution:
R1
Config t
Flow exporter Export-NetFlowENCOR
destination 10.10.1.110
transport udp 2055
exit
flow moni Monitor-NetFlowENCOR
exit
ip sla 1
http
gethttp://10.10.1.100
frequ 300
exit
ip sla schedule 1 life forever start-time now
wr
SW1
Config t
Monitor session 7 source interface e0/0
Monitor session 7 destination interface e1/1
End
Wr

Question 4

What does the LAP send when multiple WLCs respond to the CISCO_CAPWAP-CONTROLLER.
localdomain hostname during the CAPWAP discovery and join process?

A. broadcast discover request

B. unicast discovery request to each WLC

C. Unicast discovery request to the first WLS that resolves the domain name

D. join request to all the WLCs

Correct Answer: C

Question 5

Which technology is the Cisco SD-Access control plane based on?

A. SGT

B. VRF

C. CTS

D. LISP

Correct Answer: D

Question 6

Which tag defines the properties to be applied to each specific WLAN?

A. policy tag

B. AP tag

C. site tag

D. RF tag

Correct Answer: A

Question 7

Refer to the exhibit. The IP SLA is configured in a router. An engineer must configure an EEM applet to shut down the interface and bring it back up when there is a problem with the IP SLA. Which configuration should the engineer use?

A. event manager applet EEM_IP_SLAevent track 10 state unreachable

B. event manager applet EEM_IP_SLAevent track 10 state down

C. event manager applet EEM_IP_SLAevent sla 10 state down

D. event manager applet EEM_IP_SLAevent sla 10 state unreachable

Correct Answer: B

Question 8

Refer to the exhibit.

An engineer attempts to connect to another device from Route1's console port. Which configuration is needed to allow telnet connections?

A. Option D

B. Option C

C. Option A

D. Option B

Correct Answer: D

Question 9

What is one method for achieving REST API security?

A. using built-in protocols known as Web Services Security

B. using a combination of XML encryption and XML signatures

C. using a MD5 hash to verify the integrity

D. using HTTPS and TLS encryption

Correct Answer: D

Question 10

Which technology collects location information through data packets received by the APs instead of using mobile device probes?

A. RF fingerprinting

B. FastLocate

C. hyperlocation

D. detect and locate

Correct Answer: B

Question 11

Correct Answer:

See the solution below in Explanation:
Explanation:
Solution:
R3
Config#int et0/1
config-if#ip ospf priority 255
wr
R20
clear ip ospf process
yes
R10
int et0/0
ip ospf priority 0
wr
R2
clear ip ospf process
yes

Welcome to TestSimulate

Cisco Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) (350-401) Free Practice Test