HP Fast Track - Applying HP FlexNetwork Fundamentals (HP2-Z30) Free Practice Test
Question 1
Which IRF configuration, in the correct order, includes the physical interfaces in an IRF port?
Correct Answer: D
Explanation: Only visible for TestSimulate members. You can sign-up / login (it's free).
Question 2
Refer to the exhibit.
A network administrator is managing the configuration files on an HP Provision switch and executes the commands shown in the exhibit. What is the probable cause of the error message when the network administrator tries to copy the file?
A network administrator is managing the configuration files on an HP Provision switch and executes the commands shown in the exhibit. What is the probable cause of the error message when the network administrator tries to copy the file?
Correct Answer: D
Question 3
A network administrator has set up a link between two HP ProVision switches. Both switches have an IP address in VLAN 1 and can ping each other in VLAN 1.The network administrator then creates VLAN 2 and tags it to same link of both switches.
How can the network administrator verify that connectivity in VLAN2 is functional between the twoswitches?
How can the network administrator verify that connectivity in VLAN2 is functional between the twoswitches?
Correct Answer: D
Question 4
What is the initial OSPF state of a router when an interface becomes active for a segment?
Correct Answer: C
Question 5
A network administrator has an HP Comware switch that is configured with OSPF. The network administrator views the routing table and sees that a default route was learned from an OSPF neighbor (10.1.1.1). However, the network administrator wants to override this action and use a different neighbor (10.1.1 2) for the default route.
The network administrator configures this command:
[Comware] ip route-static 0.0.0.0 0 10.1.1.2
After configuring the command, the network administrator examines the routing table and notices that the original neighbor's default route is still in the routing table, but the static route is missing.
What is the cause of this problem?
The network administrator configures this command:
[Comware] ip route-static 0.0.0.0 0 10.1.1.2
After configuring the command, the network administrator examines the routing table and notices that the original neighbor's default route is still in the routing table, but the static route is missing.
What is the cause of this problem?
Correct Answer: C
Question 6
Which Access Point (AP) type corresponds to HP MSM autonomous operational mode?
Correct Answer: C
Question 7
Which configuration tool do HP Provision switches support that HP Comware switches do not support?
Correct Answer: D
Question 8
A network administrator is using Intelligent Management Center (IMC). Which protocol must the networkadministrator configure to correctly identify HP devices when performing auto discovery?
Correct Answer: A