Design WLan Solutions (MSC-121) Free Practice Test

Question 1

You are designing a WLAN for a new customer and have been given a Customer Checklist
for WLAN.
Given this checklist, please answer the test item(s) below.

Listed below are potential modifications to the client requirements. Which of the following would change the make and model of the access points selected for this design (select TWO) ?

A. Site Survivability is required

B. Wall mounting is now an option

C. Smart card support is required

D. VOIP application support is required

Correct Answer: A,B

Question 2

You are working with a new customer in a harsh climate, who is interested in establishing an outdoor wireless link between two buildings. Which of the following options below would you recommend with regard to the APs and mode?

A. Use two AP7161's set to Mesh Mode.

B. Use two AP7131's set to Mesh Mode.

C. Use two AP650's set to Mesh Mode.

D. Use two AP6532S set to Mesh Mode.

Correct Answer: A

Question 3

When Proxy ARP is enabled on the WLAN infrastructure, ARP messages originating from the wired network are:

A. Sent upon initial power-up of the mobile device

B. Always sent to the mobile device

C. Never sent to the mobile device

D. Sent when the mobile device sends request to the wireless switch

Correct Answer: C

Question 4

You are a network design engineer and are assigned to provide an enterprise S02.1X/EAP solution to secure your company's IEEE 802.11n WLAN. What networking protocol/service that provides centralized Authentication, Authorization, and Accounting (AAA) management for computers to connect and use wireless network resources can be implemented?

A. Virtual Private Networking (VPN)

B. Public Key Infrastructure (PKI)

C. Remote Authentication DialinUser Service (RADIUS)

D. Wi-Fi Protected Access (WPA) Passphrase

E. Secure Shell (SSH)

Correct Answer: C

Question 5

When designing a network with a single Access Point (AP) and all associated stations it is called a Basic Service Set (BSS) A Basic Service Set Identifier (BSSID) is used to uniquely identify each BSS. The BSSID is typically created by which of the following methods?

A. The virtual BSSID is created from the base MAC address.

B. The virtual BSSID is assigned by the manufacturer of the WLAN device

C. The virtual BSSID is a common characteristic of all devices in the BSS.

D. The virtual BSSID is the physical address of the AP Ethernet port.

Correct Answer: A

Question 6

Which of the following would NOT be marked on the blueprint or floor plan during a site survey?

A. IP address of the AP

B. Signal Strength

C. Dead spots

D. Link speeds

Correct Answer: A

Question 7

Motorola Solutions WLAN products eliminate bottlenecks and poorly performing applications by utilizing smart direct routing, which provides a more powerful, high performing, secure network. All of the following are considered benefits of Motorola Solutions smart direct routing, EXCEPT:

A. Higher Quality of Service

B. Reduces the amount of PoE devices in a typical network

C. Decreased Network Traffic

D. Greater Network Capacity

E. Increased Mobility and Roaming

Correct Answer: B

Question 8

You have been asked to develop a network design for a new customer using the application planning features of LANPlanner. You have entered the following key performance requirements into the application:
Based on these "best practice" design criteria, which of the following WLAN applications best fits this criteria? As needed, please use the exhibit at the bottom.

A. Basic Connectivity

B. VoWLAN

C. Location Tracking

D. High Performance Data

E. WiDS/WiPS Sensors

Correct Answer: B

Welcome to TestSimulate

Motorola Solutions Design WLan Solutions (MSC-121) Free Practice Test