NACE Coating Inspector Level 1 (NACE-CIP1-001) Free Practice Test
Question 1
An Inspector should change position when:
Correct Answer: A
Question 2
When the joint NACE/SSPC abrasive blast cleaning standards are specified, the pictures in SSPC VIS 1 can be used as:
Correct Answer: A
Question 3
You are the NACE Inspector on a job where ISO ST 3 has been specified. The Contractor normally works to SSPC standards and been referencing SSPC SP 3.
Could this have any impact on the final surface preparation appearance?
Could this have any impact on the final surface preparation appearance?
Correct Answer: C
Question 4
What is the minimum spot measurement value allowed by SSPC-PA 2 in each 10 m2 (100 ft2) area?
Correct Answer: D
Question 5
You are asked to be the only coating inspector on a small bridge recoating job where existing coating contains lead. The owners' representative has supplied you with the local code governing the removal and disposal of lead based coatings, however upon reading the document you having great deal of difficulty understanding the technical language.
As a NACE CIP Level 1 Inspector your preferred course of action is to:
As a NACE CIP Level 1 Inspector your preferred course of action is to:
Correct Answer: C
Question 6
Prior to the pre-job conference you notice that the Inspection and Test Plan does not require a hold point after surface preparation and coating application. In speaking with the owners' representative in advance of the meeting you sense he/she does not understand the importance of the hold point.
As a NACE CIP Level 1 Inspector your preferred course of action is to:
As a NACE CIP Level 1 Inspector your preferred course of action is to:
Correct Answer: C
Question 7
Daily reports are important because:
Select All That Apply
Select All That Apply
Correct Answer: A,C,D
Question 8
Dew point is the temperature at which
Correct Answer: A
Question 9
What is used to determine compressed air cleanliness?
Correct Answer: B
Question 10
You are the NACE Coating Inspector on an exterior job where the contractor is not using any environmental controls, For the last several hours your reading; indicate the relative humidity is rising and the substrate temperature is dropping. The sky is clouding over and the weather forecast is for evening showers. It is now 4 PM, your readings indicate you have minimally acceptable environmental conditions, however if the current trend continues, you expect to be outside specified conditions soon. The contractor advises you he is going to mix up the next full kit to complete his for the day.
Your FIRST preformed course of action is to:
Your FIRST preformed course of action is to:
Correct Answer: D