Certified Wireless Design Professional (CWDP-303) Free Practice Test

Question 1

In addition to a copy of your design, which tools should you use to ensure the installation team deploys APs where you have them designed to be located?

A. RF spectrum analyzer and packet capturing software

B. Camera and marking tools

C. Ladder and a pen

D. GPS and a map

Correct Answer: D

Question 2

Using a SCA means that all APs will be using the same channel in a given layer. How is the AP with which the client associates determined?

A. All APs share a virtual IP address. A controller will tell the closest AP to the client to communicate with it, since it has a greater RSSI from the client.

B. All APs share a virtual BSSID. A controller will tell the closest AP to the client to communicate with it, since it has a greater RSSI from the client.

C. All APs share a virtual Multicast Address. A controller will tell the closest AP to the client to communicate with it, since it has a greater RSSI from the client.

D. The client selects the AP based on a known set of MAC to BSSID mappings stored in the clients authorized SSID listing.

Correct Answer: D

Question 3

What limitation exists when WMM is not enabled on an 802.11n WLAN?

A. EDCA values will change

B. Only two ACs will be available

C. 802.11 QoS will not be available

D. The maximum channel-width will be 20MHz

Correct Answer: C

Question 4

A controller-based WLAN infrastructure has its controller on a different subnet than its APs. What device must be used to enable any communication between the Controller and the APs?

A. NTP server

B. PoE Layer 2 switch

C. Router

D. Wireless bridge

Correct Answer: C

Question 5

Aesthetics are very important in some environments. What common installation technique can be used to best meet this requirement in a stadium?

A. Painting to match team colors

B. Mounting on a non-fixed pole

C. Mounting on the walls

D. Using enclosures under the seats or on hand-rails

Correct Answer: A

Question 6

You are conducting a physical site survey where heavy machinery is repaired. What is a common item required specifically for this type of survey?

A. Indoor APs

B. Low gain antennas

C. Personal Protective Equipment (PPE)

D. Low power APs

Correct Answer: C

Welcome to TestSimulate

CWNP Certified Wireless Design Professional (CWDP-303) Free Practice Test