Aruba Certified Mobility Professional 6.1 (ACMP-6.1) Free Practice Test
Question 1
When creating a firewall policy, which of the following parameters are required? (Choose all the correct answers.)
Correct Answer: A,B,C,E
Question 2
Which profiles are required in an AP Group to enable an SSID with VLAN 1, WPA2 and LMSIP?
Correct Answer: B
Question 3
Which of the following APs do not support dual radio operations? (Choose all the correct answers.)
Correct Answer: A,B
Question 4
A customer has configured a 3000 controller with the following commands:
Vlan 55
Vlan 56
Vlan 57
Interface gigabitethernet 1/0 switchport mode trunk
switchport trunk native vlan 55
switchport trunk allowed vlan 55-57
Which of the following sentences best describes this port?
Vlan 55
Vlan 56
Vlan 57
Interface gigabitethernet 1/0 switchport mode trunk
switchport trunk native vlan 55
switchport trunk allowed vlan 55-57
Which of the following sentences best describes this port?
Correct Answer: B
Question 5
Which types of encryption will an Aruba access point perform on traffic sent through a Campus AP Virtual AP (VAP) profile in Tunnel forwarding mode?
Correct Answer: A
Question 6
Referring to the diagram provided for this question, representing an office wireless LAN deployment, there will be approximately 250 users in the offices section of the building.

According to Aruba best practice, which network device is the best choice for the wireless clients' default gateway?

According to Aruba best practice, which network device is the best choice for the wireless clients' default gateway?
Correct Answer: D
Question 7
When a port has been configured as untrusted, but no wired access AAA profile has been configured. A user connects to that port. What happens next?
Correct Answer: B
Question 8
An AP was configured to use dynamic controller discovery and assigned to an AP group, then powered off for over a week. When the AP is redeployed, what previous configuration will it retain?
Correct Answer: D
Question 9
A user logged in with the Captive Portal settings shown in the above screen capture.

What does the user need to do to logout?

What does the user need to do to logout?
Correct Answer: A
Question 10
View the Server group screen shot above.

A company has provisioned the same VAP, AAA and SSID profiles at both its Miami and NY offices. This Server Group is applied for 802.1x authentication at both locations. The user's credentials are only found in the Miami Radius server "RadiusMiami". There is no Radius synchronization. What happens when the user attempts to authenticate?

A company has provisioned the same VAP, AAA and SSID profiles at both its Miami and NY offices. This Server Group is applied for 802.1x authentication at both locations. The user's credentials are only found in the Miami Radius server "RadiusMiami". There is no Radius synchronization. What happens when the user attempts to authenticate?
Correct Answer: A
Question 11
Which of the following controllers has an integrated single radio AP?
Correct Answer: D
Question 12
A client device associates with an SSID provisioned with 802.1X authentication. The client is set for LEAP authentication. EAP termination (AAA Fastconnect) is enabled on the controller. But the client continuously cycles through the authentication process. Which of the following could cause this?
Correct Answer: A
Question 13
Which of the following are valid RAP forwarding modes (select all that apply)?
Correct Answer: A,C,D
Question 14
Which of the following statement is true of the Spectrum Mode?
Correct Answer: B