Aruba Certified Mobility Professional 6.1 (ACMP-6-1) Free Practice Test

Question 1

Referring to the diagram provided for this question, if the Aruba controller is configured to perform L3 switching, what will be the wireless user's default gateway?

A. D

B. A

C. B

D. C

Correct Answer: A

Question 2

As an admin/root user, what other types of role-based management users can be created on Aruba controllers? (Choose all the correct answers)

A. Location-api-management user

B. Guest provisioning user

C. Read only user

D. Auditing-compliance user

Correct Answer: A,B,C

Question 3

Which settings can be modified directly from a local controller? (Choose all correct answers.)

A. Switch Time Zone

B. Port VLAN setting

C. Roles

D. SNMP Enable Trap Generation

E. Port trusted

Correct Answer: A,B,D,E

Question 4

How does the ARM's Band Steering feature encourage 5GHz capable clients to move/connect to the 5GHz radios of Aruba APs?

A. ARM "hides" the 2.4GHz radios from 5GHz capable clients

B. Current Wi-Fi chipset firmware supports this by default

C. It's not possible the move clients to 5GHz radios when they can see both 2.4 and 5GHz APs

D. ARM utilizes third party software on the wireless clients

Correct Answer: A

Question 5

The reusable wizards are accessible in which one of the following ways?

A. Through the CLI, after the initial CLI wizard has been completed

B. In the Web UI under configuration.

C. In the Web UI under maintenance.

D. On startup through the CLI

Correct Answer: B

Question 6

When direct consoled to an AP, what is the command sequence to factory default the AP and re-bootstrap?

A. setenv bootstat init

B. purge, save, boot

C. init, save, boot

D. setenv master init, boot

Correct Answer: B

Question 7

Which of the following charts are available for selection in Spectrum Dashboard for AP 125?

A. Channel Quality

B. Active Devices by Channel

C. Number of Spectrum Monitors

D. FFT Duty Cycle

Correct Answer: A,B

Question 8

What does Aruba's RF self-healing require to operate?

A. None of the above

B. LMS-IP

C. VRRP

D. Backup LMS-IP

Correct Answer: A

Question 9

The permanent licenses on the controller will be deleted with the use of which command?

A. delete license

B. write erase

C. Licenses cannot be deleted once activated

D. write erase all

Correct Answer: D

Question 10

Referring to the above screen capture,

which tab tells you which licenses are installed on the controller?

A. Inventory

B. All Wlan Controllers

C. Process Logs

D. Controller Summary

Correct Answer: A

Question 11

When creating a firewall policy, which of the following parameters are required? (Choose all the correct answers.)

A. Action

B. Source

C. Destination

D. Log

E. Service

Correct Answer: A,B,C,E

Question 12

When deploying Remote Mesh Portals, what is one of the purposes of the Mesh Private VLAN?

A. To tag mesh wireless user traffic on a particular AP

B. To separate wireless user traffic coming from mesh networks from non-mesh networks

C. To allow Mesh Points to form private vlan networks with certain users

D. To tag control plane traffic from Mesh points to the controller

Correct Answer: D

Question 13

A Remote AP provisioned in "Split-Tunnel" Forwarding mode has which of the following characteristics? Choose all that apply.

A. Traffic is IPSec encrypted before it is sent to the controller.

B. The user role must have a "route src-nat" statement to locally bridge the traffic.

C. The user role must have a "Permit" statement in order to locally bridge the traffic.

D. The RAP uses UDP 4500 to send traffic to the controller.

E. Local traffic first goes to the controller and is then spilt back to the local network.

Correct Answer: A,B,D

Welcome to TestSimulate

Aruba Certified Mobility Professional 6.1 (ACMP-6-1) Free Practice Test