HP Applying HPE FlexNetwork Fundamentals (HP0-Y52) Free Practice Test
Question 1
A network administrator configures OSPF in an HP ProVision based network. The administrator is concerned that a rogue device might connect to an access layer switch and introduce OSPF routes to the company's routing topology.
The access VLANs do not contain additional routers.
Which configuration should the administrator apply for these access VLANs to prevent them from forming an adjacency with rogue devices?
The access VLANs do not contain additional routers.
Which configuration should the administrator apply for these access VLANs to prevent them from forming an adjacency with rogue devices?
Correct Answer: C
Question 2
Refer to the exhibit.
Exhibit: Network diagram and routing tables
Why does traffic from PC1 fail to reach PC2?
Exhibit: Network diagram and routing tables
Why does traffic from PC1 fail to reach PC2?
Correct Answer: D
Question 3
A company requires switches to use Multiple Spanning Tree Protocol (MSTP) instead of Rapid Spanning Tree Protocol (RSTP), so that the switches can forward traffic on more than one switch-to-switch link. How does the administrator set up the solution to meet this requirement?
Correct Answer: B
Question 4
Two switches are members in an active Intelligent Resilient Framework (IRF) virtual device. A network administrator joins a third switch to the IRF virtual device. Which switch is now the master?
Correct Answer: D
Question 5
HOTSPOT
HOTSPOT
Match the description with the 802.11 standard. (Each option may be used only once.)
HOTSPOT
Match the description with the 802.11 standard. (Each option may be used only once.)
Correct Answer:
Explanation:
Question 6
Refer to the exhibit.
Based on the topology shown in the exhibit, which symptom does a network administrator see if
the HP switches are in their factory default states?
Based on the topology shown in the exhibit, which symptom does a network administrator see if
the HP switches are in their factory default states?
Correct Answer: D
Question 7
When adding a new member to an existing IRF domain, which of the following must you perform first?
Correct Answer: A
Question 8
Which statement correctly defines the management capabilities of an HP MultiService Mobility (MSM) access point (AP)?
Correct Answer: B
Question 9
Which settings enable a network administrator to use terminal emulation software to interface with an HP Comware switch's auxiliary port?
Correct Answer: D
Question 10
Refer to the exhibit.
The network administrator has configured this port to permit all VLANs. The output in the exhibit indicates that the port is only passing VLANs 1 and 11. The administrator wants the port to pass VLAN 12 as well.
What should the administrator do to accomplish this?
The network administrator has configured this port to permit all VLANs. The output in the exhibit indicates that the port is only passing VLANs 1 and 11. The administrator wants the port to pass VLAN 12 as well.
What should the administrator do to accomplish this?
Correct Answer: B